Video Description
Learn the key considerations for installing corner trim on a wall that includes wainscot in a Worldwide Steel Buildings project. The wainscot transition introduces multiple panel layers and trim intersections at the building corner. The video emphasizes aligning the upper and lower wall sections, managing overlaps, and maintaining a clean continuous corner so builders can approach the work with a clearer understanding of the component and its place in the finished structure.
What You'll Learn
- How to coordinate upper and lower wall sections
- How to manage trim intersections at the wainscot line
- How to maintain a clean, continuous corner
Video Transcript
Once your side wall and end wall panels are in place, you may proceed with your corner trim installation.
In this video, we will be installing our corner trim with a wainscot side wall.
The corner trim will be identified on your sheet metal trim package list as corner rake trim at corners.
At the end wall corner, measure from the base trim to the bottom of the purlin.
Repeat this measurement for the side wall corner up to the top of the side wall panel.
Lay out your corner trim so that you can mark the end wall side measurement with a speed square.
Next, mark your side wall measurement.
Finally, mark your roof pitch.
The following chart will help you determine the dimensions needed for each pitch before making your cuts.
In our example, we are using a 4:12 roof pitch.
Referencing the chart, you can see that a 4:12 roof pitch has a dimension of 2 inches.
This dimension should be marked along the corner trim as shown here.
You can also use a speed square with a built-in 4:12 slope reference as demonstrated here.
Once marked, carefully cut the trim with hand snips.
Since our side wall has a wainscot, you will also need to notch out the corner to fit around your wainscot trim.
Your final cut will look like the one shown here.
If you have any questions about these measurements or how to cut your trim, then please contact the experts at World Wide Steel.
Place the trim in position, making any additional trim cuts as needed.
Your notch will accommodate the wainscot trim as shown here. The gaps can be filled with caulk at a later time. Make sure your corner is lined up on the base and runs level on both sides. The return flat of your corner trim should not fall on top of a high rib, but should overlap it as shown here.
Fasten the trim in place with sheet metal screws at every girt, matching your side wall and end wall screw lines.
Your corner trim installation is now complete.